Hoot wrote:I never realized the tolerances on the molded plastic stocks were that tight so as to be impacted by the difference between commercial vs milspec variations in buffer tubes. I've read it matters with collapsible carbine stocks, just never knew it mattered with fixed ones as well. What Gunny said about the recoil reduction making them stronger is correct. Much more solid than their normal hollow and some foam state.
Hoot
Hoot, I didn't know there was a difference in rifle tubes, diameter wise, either. I knew about the A2 adapter for length but not diameter. I emailed my supplier asking for two of each if there was a difference, if not four of what they had. With my luck I did that wrong too. I'm supposed to call Scott again tomorrow to check on the 20" uppers, it's not looking good there. I may have to go with another supplier.