Hello All
I'm new to this site and am looking for advise on reloading for the 450 B. Current load is 37.9 grains of LilGun, with a WSR primer, hornady brass cleaned and trimmed. I am shooting a CVA Scout; which has a 25 " Bagara barrel. Shot yesterday and was noticing my primers were dimpled back, showing signs of pressure. Last years load was 38.1 grains of liLGUn and did not see any signs of pressure. Any one want to weigh in on this. I have Federal small rifle primers and REmington 71/2 as well.
reloading for the 450B primer issues
Moderator: MudBug
Forum rules
Please try and keep it safe!
This information is the responsibility of the community, not the forum. 450bushmaster.net is not responsible if you blow yourselves up.
Please try and keep it safe!
This information is the responsibility of the community, not the forum. 450bushmaster.net is not responsible if you blow yourselves up.
4 posts
• Page 1 of 1
reloading for the 450B primer issues
by phoenix » Sun Nov 08, 2020 7:09 am
- phoenix
- Posts: 2
- Joined: Sun Nov 08, 2020 6:48 am
Re: reloading for the 450B primer issues
by plant_one » Mon Nov 09, 2020 5:54 pm
try the 7½'s... from what i recall reading WSR are pretty soft/relatively thin cup material
-
plant_one - Posts: 1110
- Joined: Sat Mar 19, 2016 8:58 pm
- Location: Oakland County, MI
Re: reloading for the 450B primer issues
by phoenix » Tue Nov 10, 2020 6:17 pm
I went with the Federal 205's and shot a very nice group , Remington's did not produce as tight a group as the Federal's. Has anyone used the Hornady 245 grain Interlock bullet yet on Whgitetails
- phoenix
- Posts: 2
- Joined: Sun Nov 08, 2020 6:48 am
Re: reloading for the 450B primer issues
by BIGDADDY » Tue Nov 10, 2020 6:37 pm
you might also try a copper remover in the barrel.
- BIGDADDY
- Posts: 23
- Joined: Sun Feb 10, 2019 8:08 pm
4 posts
• Page 1 of 1
Return to Reloading for the 450b
Who is online
Users browsing this forum: No registered users and 111 guests