by Moiecol » Fri Dec 08, 2023 11:19 pm
This is a powder dispenser my son printed up for me. The bottom half has a compartment filled with bb's so I can turn the knob without moving the dispenser. The tube is angled slightly and it has an internal auger to move the powder downward. It is slick as a whistle to use but I did lightly sand the two port holes so it would rotate smoothly. It took 1 hour make, used 48 grams of filament and material cost was $1.15
- Attachments
-
- 20231208_213938.jpg (99.29 KiB) Viewed 16480 times