Hoot's ears have officially perked up!
![Wink ;)](./images/smilies/icon_e_wink.gif)
Hoot
Moderator: MudBug
Exits45 wrote:The material is a High density foam from a 2" thick sheet. It's 30 lb rated.
I believe you can buy the material at McMaster/Carr. We had some laying
around the shop at work for some time. So I cut off a section and turned
the diameters and parted it off. Then epoxied them in and shaped them
to length.
Exits45 wrote:A New/old udate to this report. I just recieved my Chrony F-1 and made a remote for it. Took out the 250 gr. Deep curls and shot a couple to check the speed.
I got 2299 fps to 2333fps.
wildcatter wrote:Exits45 wrote:
FWIW, I use a 22lr to verify whether or not I have the chronograph set up for the conditions. In this way I don't waste so many of the expensive rds. Just a little thought, here...
Texas Sheepdawg wrote:Update. I just got back around to these spent 450 cases. I don't know why, but when running them through the resizing die, I was beginning to think that I had already resized them, but my primer pockets proved that I was indeed resizing "spent" brass. What I mean to say is that there was almost no force needed to run these cases up into the die and only slight force needed towards the end of the stroke. I don't know if it was just my imagination or the Imperial Wax or could it be that after these cases were shot, they suffered very little distortion? Is it me? The wax? Hmmmmm.
Return to Reloading for the 450b
Users browsing this forum: No registered users and 144 guests